Contributors in Industrial valves
Industrial valves > Control valves 
trunnion mounting
Industrial valves; Control valves
A style of mounting the disc or ball on the valve shaft or stub shaft with two bushings diametrically opposed.
lock-up valve
Industrial valves; Control valves
A special type of regulator that is installed between the valve positioner and the valve actuator, where it senses the supply air pressure. If that pressure falls below a certain ...
anti-cavitation trim
Industrial valves; Control valves
A special trim used in control valves to stage the pressure drop through the valve, which will either prevent the cavitation from occurring or direct the bubbles that are formed ...
packing
Industrial valves; Control valves
A sealing system that normally consists of a deformable material such as TFE, graphite, asbestos, etc. It is usually in the form of solid or split rings contained in a PACKING BOX ...
lantern ring
Industrial valves; Control valves
A rigid spacer used in the packing with packing above and below it. The lantern ring is used to allow lubrication to the packing or allow access to a leak off connection. On some ...
booster
Industrial valves; Control valves
A pneumatic relay that is used to reduce the time lag in pneumatic circuits by reproducing pneumatic signals with high-volume and or high-pressure output. These units may act as ...
seat ring
Industrial valves; Control valves
A part of the flow passageway that is used in conjuction with the closure member to modify the rate of flow through the valve.
Sub-categories
- Control valves (3490)